We design and install modern automatic irrigation systems that give plants the water they need while saving considerable water and time. Every system is matched to the size and conditions of the garden and to the needs of its planting.
Besides installing new systems, we service, repair, commission and winterize existing ones. With modern controls your garden gets the care it needs even while you are away.
Flow measurement, a zoning plan, spray patterns and a materials list.
Machine trenching that spares the lawn, plus pipework and cabling.
Pop-up sprinklers, drip lines and a clear zone layout.
A programmable controller, rain sensor and control from your phone.
Pressure setting, fine-tuning of spray patterns and a handover walkthrough.
Compressor blow-out, spring start-up and repairs.
No. We use a lawn-friendly trenching machine that cuts a narrow slot, and the grass closes over it within two to three weeks. In a new garden the system goes in before the lawn is laid.
Compared with hand watering, water use is typically 30 to 50 percent lower, because the system waters at dawn with a measured amount per zone, and the rain sensor skips unnecessary cycles.
Either can work. During the survey we measure the available flow and pressure and design the zones around them. Where needed, we add a buffer tank and a booster pump.
Yes. We carry out fault-finding, sprinkler and valve replacement, controller programming, spring commissioning and autumn winterization on systems built by others as well.
